Alpine 3544 - Switches and Terminals; Input Mode Selector Switch Settings; Fixed;Variable Input Selector Settings

Switches And Terminals
| 3544
ALPINE nee oceans cowie sansa pare conte are
Q)
=e
bi ia
iB}
cf EY cf ey
i i
Input Gain Adjustment Controi
Input Gain Selector Switch
Input Mode Selector Switch
RCA input Jacks
Speaker Output Terminals
@©OO8L9O
Switch Settings
+ Input Mode Selector Switch @:
a) Set to the "ST" position (center) when the amplifier is
used as a 2-channel stereo system.
ll
LIMONO) ST L+R
b) Set to the "L (MONO)" position when the amplifier is
used for one channel of a stereo or bridged system.
(uct) eos
Li(MONO) ST L+R
c) Set to the "L+R" position when the amplifier is used for
subwoofer system which uses the rignt channel and left
channel signals summed.
1S
LiMONO) ST L+R
Fuses
©
@ Power Supply Terminals
Remote Turn-On Connector
© Status Monitor
* Fixed/Variable Input Selector Switch @:
a) Set to the "FIXED" position when connecting the 3544
to other Alpine products. This position sets the input
sensitivity to 500mV which corresponds to the preamp
output of Alpine products.
—
VARIABLE — FIXED
b) Set to the "VARIABLE" position when connecting the
3544 to a non-Alpine product with an output voltage
other than 500mV. This position should also be used
when adjustment of input sensitivity is required to
obtain certain imaging requirements or to compensate
for different speaker efficiencies.
1
VARIABLE FIXED