Carefully close and lock cover and then switch the dispenser is power on
BASIC USE
Upon initial use (or after a long period of time the unit is left unused), activate the sensor
by hand several times in order to clean the air in the pipe
Drop: Gel Soap or Gel Sanitizer
Spray: Medical Alcohol Liquid [ Fog ]
WA R N I N G
IMPORTANT
Check soap qualities, properties and level in soap/sanitizer tank.
Check sensor cover for dirt obscuring the lens.
Check battery charge level.
Check spout nozzle, soap dispensing tube for clogs.
Check if the ON/OFF switch [ Installation “7" ] is at the correct position
Check if the soap tank is located at the right hanging bracket [ Installation “3"].
Activate the dispenser sensor several times for first time use or after long time
unuse. Some soap [ Sanitizer ] becomes blocked within the pipe if the unit is
unused for a prolonged period of time
Check if the soap tank leakage.
Check if dispense
r tube connection has become loose.
Check disposable soap pump for defects and/or needs replacement.
Remove soap tank & wash out spout nozzle, clean dispenser tube by water.
Check if the tube is loose without cross-threaded.
Soap not dispensing
Soap leaking
Low quantities of
soap dispensed
TROUBLESHOOTING
To Next Page
Loading...
