Alpine 7289M - Page 14

«RADIO OPERATION?
MANUAL and AUTOMATIC SEEK TUNING
The
radio
does
not
operate
in
the
tape
play
mode.
To
listen
to
the
radio,
press
the
TUNER
BAND switch @.
1.
2.
3.
Turn on the power by turning the Power On/OFF switch @ clockwise. Continue to
rotate it until the desired volume level is reached.
Press the TUNER BAND switch @ to activate the radio mode.
Press TUNER BAND switch @® for reception of MW, LW, or FM (FM1 or FM2). The
radio BAND Indicator @ will be on, and the ST [stereo] indicator @ will also be on
during FM stereo reception.
Adjust BASS @, TREBle @, BALance @, and FADer ® controls to their centre
positions.
To automatically tune, press the TUNE switch @ until the SEEK indicator ® is
displayed. Press the UP or DN tuning switch and the frequency changes to the next
receivable station. Repeat the procedure until your desired station is obtained. When
the radio reaches the upper or lower end of the band, it automatically starts scanning
from the opposite end. To return to manual tuning, press the TUNE switch again, the
SEEK indicator disappears and the TUNE indicator lights up.
To manually tune, press the Tuning Switch (UP) @ for higher frequency broadcasts,
and press the Tuning Switch (DN) @ for lower frequency broadcasts.
Adjust VOLume @, BASS @, TREBle ©, BALance @, and FADer , to suit your
listening preference.
To switch from FM to MW (or LW) or vice versa press the TUNER BAND select switch
@®.
Memory Operation
Select FM1, FM2, MW or LW by pressing the TUNER BAND select switch @.
Select a station manually or by SEEK tuning.
Press and hold a Station Preset switch for more than 2 seconds to preset the station
in MEMORY.
The station display blinks for 5 seconds indicating that the station can be stored into
the preset memory.
Press the Station Preset button for a second time while the station display is blinking.
Now, the station is stored into the preset memory.
Press one of the unused Station Preset switches @ each time.
Note: For the D.A.P. band you can preset up to 6 MW, LW and FM stations eed:
Press the TUNER BAND select switch @ to preset six stations on another band.
Follow Steps 2, 3, 4, 5, and 6. Remember, there are altogether five (FM1, FM2,
MW, LW and D.A.P.) bands.
To select a frequency programmed into memory, press the desired station preset
switch, 1 through 6. If the radio is set to MW, you'll receive an MW frequency. If in
the FM mode, you'll receive an FM station.
When you select one of the six presets, an orange dot will light up in the upper right
hand corner of that preset button. This is the direct preset indicator.
14