BREAKDOWN RECOVERY
5
180 - Practical advice
Refitting the scuttle panel grille run
channel
It is important to properly reposition the
run channel
3
.
To do this:
– position the run channel
3
(movement
D
);
– depending on the vehicle, insert the
run channel
3
into the wing cover
housing
6
(movement
E
);
– clip the component
5
at each end of
the run channel to the bodywork
mounting
4
(movement
F
);
– press the run channel (movement
G
) to clip it in.
Note: if you have difficulty clipping
on the run channel
3
(movement
G
),
check if it has been inserted into
components
4
and
6
: risk of
damage to run channel.
To Next Page
Loading...