BREAKDOWN RECOVERY
5
Practical advice - 181
Depending on the vehicle, unclip the
battery cover.
Lift the red tab
11
to access the
terminal
8
(+). Connect the positive
cable
H
to the terminal
8
(+) then to
the terminal
9
(+) of the battery
supplying the current.
Connect the negative cable
G
to the
terminal
10
(˗) of the battery
supplying the current and then to
the terminal
7
(˗)ofthedischarged
battery.
Start the engine of the vehicle
supplying the current and run it at
intermediate engine speed.
Ensure that there is no
contact between cables
G
and
H
and that the
positive cable
H
is not in
contact with any metallic
component in the vehicle
supplying the current.
Risk of injury and/or damage to
the vehicle.
If your vehicle's engine does not start
immediately, switch off the ignition and
wait a few seconds before repeating
the operation.
With the engine switched running,
disconnect cables
G
and
H
in the
reverse order (
7
-
10
-
9
-
8
).
To Next Page
Loading...