Alpine CDA-9833R User Manual

31-EN
MobileHub™ Link
Operation(Optional)
About MobileHub™ Link
Connect a separately sold junction box and a portable telephone
(available from Nokia) to control the incoming and outgoing calls of
the portable telephone.
Caution
Even with hands-free operation, a driver can be distracted during
telephone operation or receiving a call. For the sake of safety,
drivers are requested to refrain from operating the telephone while
driving.
For the sake of safety, only incoming calls and Speed-Dial
outgoing calls can be operated.
• If a portable telephone is connected, its address book, incoming
and outgoing history are downloaded to the junction box.
•Please refer to the instruction manual of the junction box.
Telephone Mode ON/OFF
1
Press and hold BAND/TEL. for at least 2 seconds
to turn on the Telephone mode.
To turn off, press BAND/TEL.
See relevant pages for each item.
• “NO PHONE” is displayed for about 2 seconds, if a portable
telephone is not connected, before entering the telephone mode.
Then the mode returns to the original source mode.
• When the portable telephone is taken off the junction box during an
incoming or outgoing call, or during a hands-free call, the call will
be treated as an ordinary one by the portable telephone.
• When there is an incoming call while the power of CDA-9835R/
CDA-9833R is off, the power of CDA-9835R/CDA-9833R will turn
on automatically for a hands-free call.
• Even if the power of the portable telephone is off, when CDA-
9835R/CDA-9833R is set to Telephone mode, the power of the
portable telephone will be turned on.
• Even if the ACC power of the vehicle is turned off (even if the
engine is stopped) during a hands-free call, the call is not
disconnected, and an ordinary call by the portable telephone is
possible.
• If there is an incoming call during operation (except an outgoing
call or talking), operation mode will end and switch to the
incoming or talking mode.
Preset buttons
(1 through 6)
BAND/
TEL.
f g
SEARCH/Q.S.
F
-/J
9
8TITLE
• An outgoing call from a portable telephone is also possible.
However, you cannot perform different operations at the same time
from a portable telephone and CDA-9835R/CDA-9833R as
malfunction can result.
•With a junction box connected outgoing, incoming, and sending
history will also be recorded in the portable telephone.
• While telephoning, defeat is set to ON. When the call has finished,
the unit returns to your previous setting.
• The telephone volume can be adjusted on the CDA-9835R/CDA-
9833R. The volume you set during the call is memorized, and is
automatically applied again on the next call.
• While telephoning or receiving incoming calls, press TITLE to
show the Network Operator display for 5 seconds.
Incoming Calls
1
Press :/J to receive an incoming call.
2
Press BAND/TEL. to finish a call.
Telephone mode will end and return to the original source
mode.
• When the Automatic Calling mode is on, you can talk after 3
seconds of receiving the incoming call. (see “Setting the Automatic
Calling” on this page.)
Setting the Automatic Calling
The incoming call can be switched to Automatic Calling or Manual
Calling.
1
Press MENU to select the SETUP mode.
2
Select “TELEPHONE” by pressing g or f.
3
Turn the Rotary encoder to change to AUTO or
MANUAL.
4
Press and hold MENU for at least 2 seconds to
return to normal mode, or press MENU and select
RETURN to return to normal mode.
•Press BAND/TEL. during an incoming call to disconnect it.
• The initial setting of the factory is MANUAL.
MENU Rotary
encoder

Alpine CDA-9833R Specifications

General

Brand	Alpine
Model	CDA-9833R
Category	Car Receiver
Language	English