7-EN
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press (Release) at the upper left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
•To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
2
1
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
•Attach the front panel carefully, holding the sides of the front panel
to avoid pushing buttons by mistake.
SOURCE/
POWER
BAND/
TEL.
g f
TUNE/
A.ME
Preset buttons
(1 through 6)
Radio
Listening to Radio
1
Press SOURCE/POWER until a radio frequency
appears in the display.
2
Press BAND/TEL. repeatedly until the desired
radio band is displayed.
FM1 → FM2 → FM3 → MW → LW → FM1
3
Press TUNE/A.ME to select the tuning mode.
CDA-9835R:
DX (Distance mode) → LOCAL (Local mode) →
MANUAL (Manual mode) → DX
CDA-9833R:
DX SEEK (Distance mode) → SEEK (Local mode) →
OFF (Manual mode) → DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press g or f to tune in the desired station.
Holding down g or f will change the frequency
continuously.
• The ST indicator appears on the display when a stereo FM station
is tuned in.
SEARCH/Q.S.
FRotary
encoder
To Next Page
Loading...
Need help?
General
