Alpine CDE-135BT User Manual

11-EN
Presetting Stations Automatically
1 Press BAND repeatedly until the desired radio band is
displayed.
2 Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
Select the band, and then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Note
•If the  indicator is illuminated, turn off the indicator by pressing
and holding FUNC.VIEW for at least 2 seconds, and then you can
perform the operation.
Frequency Search Function
You can search for a radio station by its frequency.
1 Press and hold ENTER for at least 2 seconds in Radio
mode to activate Frequency search mode.
2 Turn the Rotary encoder to select the desired frequency.
3 Press ENTER to receive the selected frequency.
Note
•Press  in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
Turning AF (Alternative Frequencies) ON/OFF
The RDS (Radio Data System) is a radio information system using the
57 kHz subcarrier of regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic information, station
names, and to automatically re-tune to a stronger transmitter that is
broadcasting the same programme.
1 Press and hold FUNC.VIEW for at least 2 seconds so that
the  indicator lights up.
2 Press 1AF to select the AF (Alternative Frequency) ON or
OFF mode.
3 Press and hold FUNC.VIEW for at least 2 seconds to
activate the normal mode.
The  indicator goes out.
Notes
• When the AF ON mode is selected, the unit automatically tunes to a
strong signal station in the AF list.
• Use the AF OFF mode when automatic re-tuning is not required.
• When the PTY31 (Emergency Broadcast) reception is set to on (refer to
“Setting PTY31 (Emergency Broadcast) reception” on page 12), if the
unit receives the PTY31 (Emergency Broadcast) signal, the unit will
show “ALARM” in the display automatically.
• Operate the unit while the  indicator lights up. If no operation is
performed for 5 seconds, the  indicator goes out.
The RDS digital data includes the following:
RDS
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
EON Enhanced Other Networks


/TA
AUDIO/SETUP
FUNC./VIEW
1/AF
2/NEWS
3/PTY
Rotary encoder

Alpine CDE-135BT Specifications

General

Brand	Alpine
Model	CDE-135BT
Category	Car Receiver
Language	English