31-EN
2
Mount the unit on the floor.
Mount the unit on the floor with flanged selftapping screws
(M5 × 15) 5 and spring washers (M6) 6.
Warning: Do not damage pipe or wiring when drilling
holes.
When mounting with floor base brackets
1
Mount the brackets 1 on the unit.
Mount the brackets 1 at both sides of the unit with
screws with double washer (M5 × 10) 3.
2
Determine mounting position of the unit under the carpet.
3
Cut the carpet in “x” shape with a cutter and insert the
floor base 2 from the underside of the carpet, peel off
the protective seal on the back of the floor base, then
put the floor base on the floor.
4
Mount the unit on the carpet with spring washer (M6)
6 and wing nuts (M6) 8.
2
8
6
3
3
1
6
5
2
To Next Page
Loading...
