21-EN
Connections
• There are two types of connections to output sound. Only one connection type is valid at one time. Make the selection as shown below.
*1 When “AUX” is set in “Setting Sound Output (Output Mode)” (page 15), connect to a device with an external input.
*2 Depending on regulations, an optional FM Switching Box may be required. Consult your Alpine dealer.
If the FM Switching Box is connected, set to “Wire Transmitter” in “Setting Sound Output (Output Mode)” (page 15).
*3 FUSE (2A) is built-in.
• Do not mount the Cigarette lighter I/F Box where it might be stepped upon. Excessive pressure can damage the box.
• Depending on the mounting location of the Cigarette lighter I/F Box, noise interference is possible. When using a Bluetooth compatible device, if
noise or a malfunction occurs when sending or receiving data, mount the I/F Box in another location.
• Before using, check that the monitor and stand assembly is mounted securely at the chosen mounting location.
*1 Mini-Jack Cable
(sold separately)
To connect to a device
used for external input
Cigarette Adapter Extension
Cable (Included)
Cigarette Adapter
(Included)
or
To connect to the cigarette
receptacle on the car side
Monitor
FM Cable From Vehicle’s Antenna cable
To Head Unit’s Antenna cable
FM Modulator Antenna Cable
Monitor Cable (Included)
FULL SPEED™
Connection Cable
(Included)
iPod
(Sold separately)
Microphone (Included)
*3
FM Switching Box (KWE-155B)
(Sold separately)
Cigaratte
I/F Box
*2
To Next Page
Loading...
