4. Add the Fountain Topper by plugging the single
pin connector from the Topper to the Pump. Then
attach the tubing to the top of the pump. Now
place the pump back into the basin and set the
Topper on top of the Fountain Basin squarely.
5. On the outside of the fountain, pull the cord out
through the bottom of the Fountain and plug the
transformer into the two-pin connector. Secure by
twisting the lock collar.
6. Gently pour water into the fountain basin, being
careful not to overflow and cause splashing. Make
sure the water completely submerges the pump
and the water runs clear during operation.
NOTE: We recommend that you use distilled water
to prevent scale build-up. The first time you operate the
pump it can take up to 5 minutes for the air to be completely
expelled and water begins to flow properly
7. Plug the pump into your local power supply. Make
sure that there is no water around the plug &
always keep the power source in a dry place.
To Next Page
Loading...
