Alpine GIL786 - Replacement Part

8. Congratulations, your fountain is now complete.
Don’t forget to add water regularly as water will
evaporate over time.
• Pump, Transformer and Light Kit……RLA192
• Fountain Care Formula…………….....PPL102
Foam and scale remover for indoor and outdoor fountains.
• Americana® UV Acrylic Sealer ...……RRR106
Provides protective clear coating for all painted surfaces.
2. Next install the pump into the Fountain Basin,
where you will find two cords extending out from
the Pump. The double pin cord will go through the
Rubber Stopper, down the middle tube. And out
the bottom of the Fountain basin.
3. Adjust the flow control to the middle setting to
avoid splashing until the fountain is completely
assembled. Note: The fountain will need to be
partially disassembled in order to adjust once
complete.
Alpine Quick Tip
Switch to the Left
to turn down the
water flow. Turn
the switch to the
Right to turn up the
water flow.
ALSO AVAILABLE FROM ALPINE
REPLACEMENT PART ITEM#
5
6
8