Alpine iXE-W400E - System Settings and Installation; Customizing System Settings

1
Click to enter setting menu.
Setting
Brightness Setting: Click the button 【Enter】
on the right side to enter brightness adjustment
interface.
AUTO: Set the backlight brightness into automatic,
meaning that it will adjust automatically based on
the detection by small lamps
Day: Set the backlight brightness into daytime
mode, and 7 levels are available for adjustment.
The intermediate value is defaulted.
Night: Set the backlight brightness into night
mode, and 7 levels are available for adjustment.
The intermediate value is defaulted.
Sound Setting: Click 【Enter】 on the right side
to enter sound effect adjustment page at default.
You can choose sound effect adjustment and
sound field adjustment at the top of the page.
16-EN
10
3
2
9
4
5
6
7
8
1
11
12
13
14
15
16
2
3
Key Sound: Beep available on operation panel
and direction control button with high, mid and
low volume level and defaults to “mid”,
OFF: Close beep on the button.
4
Bluetooth Setting: Click 【Enter】 on the right
side to enter bluetooth setting interface. See
details in page 5-9 of bluetooth setting function.
5
6
3)
4)
1)
2)
3)Display the position of acoustics and sound
effect inside your vehicle.
4)Click to adjust the position of acoustics
and sound effect, and click to restore the
position of acoustics and sound effect to centre
point (default).
2)There are 7 sound effect modes to choose with
“standard“ being defaulted.
FM Frequency: Stepping setting of radio.
50KHz: 50KHz for FM stepping;
100KHz: 100KHz for FM stepping (defaulted).
Microphone Vol: High, mid and low volume
setting and defaults to “mid”.
1)Sound effect setting (8 types), and sound effect
value can be set under respective sound mode.