Alpine KCE-250BT - Connections; Connecting the BLUETOOTH INTERFACE to a compatible Alpine Unit

Connections
Connecting the BLUETOOTH INTERFACE to a compatible Alpine Unit
Before the operation, be sure to set "INT MUTE" and "AUX+" (in the setup function of the connected
head unit*) to OFF.
* Head unit includes CD Head Unit, AV Head Unit and Digital Media Receiver:
• When the KCE-250BT is connected
to a head unit, the [NT MUTE setting may not be possible, depending on the head unit.
• The AUX+ setting may not be possible. depending on the head unit.
• For details, refer
to the Owner's Manual of the head unit.
Connections for the head unit with Full Speed connector I BLUETOOTH INTERFACE connector
Example for BLUETOOTH compatible unit:
INA-W900, IVA-NAV-10. IVA-D511 Series, iXA-W404 Series, iDA-X313/311/305/303/301 Series, CDA-118M/117/105 Series,
CDE-W203/112Ri/111/102/101 Series
• About information of BLUETOOTH compatible units other than the above mentioned. please contact your local official Alpine
dealer
or visit Alpine home page.
BLUETOOTH
compatible Unit
(Sold separately)
r.:::=.-- --
i
\ I
It--------lJI
t-----.::=:@~lHj ®
(If the BLUETOOTH INTERFACE is
t----""?"'".;;;;:®~lllj connected, you cannot use a
device connected to the INT lead
Fuse (7.5 A)
_~~ (voice interruption, etc.).)
I
CD To Full Speed connector I BLUETOOTH
INTERFACE connector
® BLUETOOTH INTERFACE Cable (Included)
@ Microphone (Included)
@ Audio Interrupt Out lead (Pink/Black)
Be sure to connect only when power is turned off,
as a malfunction may result.
@) Audio Interrupt In lead (Pink/Black)
® ACC (Ignition) lead (Red)
To the ACC Power lead.
(j) Battery lead (Yellow)
Connect this lead to a terminal that constantly
provides power (to the positive
(+) post of the
battery).
@ Ground lead (Black)
Connect to a metal part of chassis body with screw.
II.EN