Operating
Instructions
WARNING
&
WARNING
This symbol means important instructions.
Failure to heed them can result
in
serious
injury or death.
DO
NOT
DISASSEMBLE
OR
ALTER.
Doing so may result
in
an accident, fire
or
electric shock.
KEEP
SMALL
OBJECTS
SUCH
AS
BATTERIES
OUT
OF
THE
REACH
OF
CHILDREN.
Swallowing them may result
in
serious injury. If swallowcd,
consult a physician immediately.
USE
ONLY
IN
CARS
WITH
A
12
VOLT
NEGATIVE
GROUND.
(Check with your dealer if you are not sure.) Failure to do so may
result
in
fire, etc.
BEFORE
WIRING,
DISCONNECT
THE
CABLE
FROM
THE
NEGATIVE
BATTERY
TERMINAL.
Failure to do so may result
in
electric shock or injury due to
electrical shorts.
DO
NOT
SPLICE
INTO
ELECTRICAL
CABLES.
Never cut away cable insulation to supply power
to
other
equipment. Doing so will exceed the current carrying capacity
of
the wire and result
in
fire
or
electric shock.
DO
NOT
DAMAGE
PIPE
OR
WIRING
WHEN
DRILLING
HOLES.
When drilling holes
in
the chassis for installation, take
precautions so as not to contact, damage
or
obstruct pipes, fuel
lines, tanks or electrical wiring. Failure to take such precautions
Illay result
in
fire.
DO
NOT
USE
BOLTS
OR
NUTS
IN
THE
BRAKE
OR
STEERING
SYSTEMS
TO
MAKE
GROUND
CONNECTIONS.
Bolts or nuts used for the brake or steering systems (or any other
safety-related system), or tanks should NEVER be used for
installations or ground connections. Using such parts could
disable control
of
the vehicle and cause fire etc.
DO
NOT
ALLOW
CABLES
TO
BECOME
ENTANGLED
IN
SURROUNDING
OBJECTS.
Arrange wiring and cables
in
compliance with the manual to
prevent obstructions when driving. Cables
or
wiring that obstruct
or hang up on places such as the steering wheel. shift lever. brake
pedals, etc. can be extremely hazardous.
USE
THIS
PRODUCT
FOR
MOBILE
12V
APPLICATIONS.
Use for other than its designed application may result
in
fire,
electric shock
or
other injury.
MAKE
THE
CORRECT
CONNECTIONS.
Failure to make the proper connections may result
in
fire or
product damage.
2.EN
&
CAUTION
This symbol means important instructions.
Failure to heed them can result
in
injury or
material property damage.
USE
SPECIFIED
ACCESSORY
PARTS
AND
INSTALL
THEM
SECURELY.
Be sure to use only the specified accessory parts. Use
of
other
than designated parts may damage this unit internally or may not
securely install the unit in place. This may cause parts to become
loose resulting in hazards or product failure.
DO
NOT
INSTALL
IN
LOCATIONS
WITH
HIGH
MOISTURE
OR
DUST.
Avoid installing the unit
in
locations with high incidence
of
moisture
or
dust. Moisture
or
dust that penetrates into this unit
may result
in
product failure.
HAVE
THE
WIRING
AND
INSTALLATION
DONE
BY
EXPERTS.
The wiring and installation
of
this unit requires special technical
skill and experience. To ensure safety, always contact the dealer
where you purchased this product to have the work done.
ARRANGE
THE
WIRING
SO
IT
IS
NOT
CRIMPED
OR
PINCHED
BY
A
SHARP
METAL
EDGE.
Route the cables and wiring away from moving parts (like the
seat rails) or sharp or pointed edges. This will prevent crimping
and damage to the wiring.
If
wiring passes through a hole
in
metal, use a rubber grommet to prevent the wire's insulation from
being cut by the metal edge
of
the hole.
To Next Page
Loading...
