Alpine PXA-H800 - Location of Controls

ALPINE PXA-H800_EN 68-13530Z66-A (B5)
5-EN
Mounting the Commander Unit (RUX-
C800) (Sold separately)
Preparation
1 Check accessory parts.
A
Commander cable (5 m)
B
Commander unit holder
C
Bracket
D
Screw (M3 × 6 mm)
(×2)
(×2)
E
Self-tapping screw
(M4 × 14 mm)
F
Adhesive sheet (1 set)
(×4)
(a)
(b)
(c)
(d)
Installing with Adhesive sheet
Set the installation location.
Check that the provided cord is sufficiently long. Install the unit where
it is not exposed to water.
Do not install the unit or wiring where it interferes with driving or
an air bag.
1 Using the Adhesive sheet (a) F, install on the console
or dashboard.
Console or Dashboard etc.
Commander Unit
Peel off
Adhesive sheet (a)
e
•
Installing with Commander unit holder
Set the installation location.
Check that the provided cord is sufficiently long. Install the unit where
it is not exposed to water.
Do not install the unit or wiring where it interferes with driving or
an air bag.
Console or dashboard, etc.
Remove the components to which this product will be installed from
the automobile before installing.
1 Cut out the external box paper template along the
perforation.
2 Temporarily hold the paper template in place at the
installation position with adhesive tape.
3 Cut installation holes along the paper template with a
utility knife.
WARNING
When making holes, be careful not to damage pipes, tanks, electric wires,
etc.
Doing so could lead to accidents or fire.
Console or Dashboard etc.
Paper template
CAUTION
If the installation holes are too big, the Commander unit can rattle or come
off while driving. Make sure to use the paper template.
e
•
•
*
erent.
c
der
sun
ation
eres
e base,
e using
as