Not
e:
When a sound source
is
selected,
it
cannot then be
selected again
as
the
mix
sound source;
doing
so
causes
the
mix
sound source
to
be invalid,
as
shown
in
Figure 7-2.
If
no
operation is performed for
about
4 seconds,
it
will
exit
from
the
interface
to
the
main
interface (Master Volume Interface).
Figure 7-2
Channel Settings
Press
the
button
briefly
to
select
the
COAX
(Digital),
USB,
BT
(Bluetooth), Hi.L (High Level},
AUX
(Low
Level)
or
OFF
mode
to
enter
the
channel settings
interface,
as
shown
in
Figure 8-1. The
output
type
of
channel 1 speaker can
be
selected
by
turning
the
button
in
the
following
order: Full-range, Tweeter,
Woofer, Subwoofer, and Mid-range. After selection,
press
the
button
briefly
to
confirm
the
channel type.
And
if
CH-1
is synchronized
to
the
Tweeter type,
it
will
be
displayed. Then
turn
the
button
to
the
right
to
select
the
speaker
type
in
the
order
of
Woofer
➔
Subwoofer
➔
Mid-rang, and
turn
the
button
to
the
left
for
Full-rang.
At
the
same time, press
the
button
briefly can also
be
directly switched
to
2~6 channel,
and
the
corresponding channel settings.
Figure
8-1
12
-EN
When the wire controller is
in
the
channel 6 setting
interface, press
the
button
briefly
to
enter
the
CAUTION
page,
as
shown in Figure 8-2. Turn
the
button
can choose
to
save
or
skip,
and
press
it
briefly
to
determine
the
selection. After
the
selection is complete,
it
will
automatically
exit
from
the interface
to
the
main interface.
Figure 8-2
To Next Page
Loading...
