Jeep
UNLIMITED
Passenger Seat Removal
1. Using an 18mm socket, extract the (4) seat bolts
from the passenger side seat. Save seat bolts for
later.
Front view
2. Using a T45 Torx extract (1) bolt from the seat belt
anchor.
4. Position the seat in a secure manner to gain access to
the bottom of the seat. Using a T30 Torx, remove the OEM
harness mounting plate as shown below. Use a panel removal
tool to remove the two plugs from the mounting plate.
Rear view
Use caution when removing the seat.
4/6
Disconnect the battery before continuing
3. Disconnect the two connectors from the seat base.
May vary depending on the trim.
To Next Page
Loading...
