6490009ENLZ / 6790009ENLZ
►
7
◄
Al
sipercha with housing tube Alsipercha System
3.- Install the sling and the retractable device.
Sling Retractable device
Detail of sling installation:
To move the Alsipercha to its location on the column,
and to remove it once hazardous operations have been completed.
Precautions
:
Warning
. Precautions:
- Use the slings supplied by Alsina.
- Do not allow loads to rest on the sling if they could damage it.
- Protect the sling against adverse weather conditions.
- Each sling should be examined before use. Remove the
sling if it presents cuts, especially at the edges.
- Place the sling in its correct position (bight angles no
greater than 120º and stable load).
It is possible to extend the range of action of the Alsipercha, but following a
specifi c alternative work sequence. See page. 10
Detail of the installation of the retractable device with the fall arrest system.
It is important to close the clasp properly.
Check:
Info
. Before using the retractable device, check:
- That the strap winds and unwinds completely without
diffi culty.
- That the locking function works correctly, by jerking the
strap.
- That the entire assembly is in perfect condition, with no
cuts or loose threads.
- That the metal parts are not rusted and the snap hooks
work and close correctly.
Step 3/4_Installing and using the Alsipercha
1.- Use a crane to place the Alsipercha Body into the housing tube.
2.- 36 hours after pouring the column concrete, the Alsipercha can be
used to: install boards, handrails, risers,...
When all the boards, handrails, netting for perimeter and openings
have been put in place and the perimeter boards have been nailed and
watered (dry climate), the Alsipercha Body can be removed.
Now we can start the panelling process from one end of the fl oor,
working in an assured position with a radius of 6.5 m., which is
equivalent to about 125 m
2
.
To Next Page
Loading...