Alsina ALSIPERCHA - Working with the Alsipercha System; Initial Setup and Boarding Process; Post-Fall Scenario and Rescue

1
7
8
9
10
11
2
3
4
5
6
6490009ENLZ / 6790009ENLZ
►
9
◄
Al
sipercha with housing tube Alsipercha System
Working with the Alsipercha System
First, locate the embedded tubes in the columns where the Fall Arrest
System is going to be accommodated and then begin the boarding
process from that point.
Position after Fall
LEGEND
1. Alsipercha
2. Housing tube
3. Column
4. Formwork
5. Struts
6. Ground
7. Anchor point
8. SRL
9. Braking distance
10. Harness extension
11. Worker
Info . Rescue of worker after a fall: It is important that when
workers work with the Alsipercha Fall Prevention System,
they are not alone. In this way, in the event of a fall, the other
worker can rescue the other, hopefully within a few minutes,
in order to prevent injury due to loss of blood circulation in
the legs. The rescuing worker, anchored to a safety point
uses a hook to carry the trapped worker to the panelling
area, in order to be able to stand up.
400 mm Retractable position
300 mm (Retractable device
extension)
Braking distance
1500 mm Distance to the
centre of gravity of the
support bases
Safety Height
> 1000 mm
Then begin the boarding process from one end of the surface and work
safely with a radius of 6.5 m, which equals approximately 125 m
2
.
3,500 mm