Altec Lansing 1707C - Page 18

NOTE
A high compression ratio and a low
threshold setting may decrease the
system's apparent loudness since peak
signals and parts of the nominal signal
may lie above the threshold. You can
correct this by raising the threshold
level; just rotate the THRESHOLD
control clockwise.
If you installed the 1783 line output
module, adjust the output level control on
the 1783 for the desired output level. The
higher the output level, the better the
signal-to-noise ratio. However, too high a
level reduces the available headroom and
may cause premature clipping.
NOTE
tf you set the 1783'3 output level con-
trol at its MAX (full clockwise) level, the
output level is +8dBm. However, this
level only applies if you use a 100
mvrms reference level on the input of
the output module from the mix output
bus. lt also only applies if you have a
balanced 600 Q load.
12
WARNING
Repair performed by other than auth-
orized warranty stations (dealers) or
qualified service personnel shall void
the warranty period of this unit. To
avoid loss of warranty, see your near-
est ALTEC LANSING authorized deal-
er. You can also call ALTEC LANSING
CUSTOMER SERVICE authorized deal-
er. You can also call ALTEC LANSING
CUSTOMER SERVICE directly at
405/324-5311, FAX 405/324-8981, or
write:
10500 W. RENO
OKLAHOMA CITY, OK 73128 U.S.A.