Altech ALEC-42090D - Selection of Temperature Display;Humidity; Configuration of Altech V3 IP Base Station

114
NO
DK
FI
SE
FR
GB
GB
2. Select the symbol “ “ and confirm the selection by shortly pressing the set-
ting wheel.
3. Turn the setting wheel and confirm the desired offset (max. ±3.5 °C) by shortly
pressing the wheel.
6.1.8 Selection of temperature display/humidity
The display alternately shows the actual or the set temperature as well as the hu-
midity, as required.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol “ “ and confirm the selection by shortly pressing the setting wheel.
• “ACT” for displaying the actual temperature or
• “SET” for displaying the set temperature or
• “ACtH” for displaying the actual temperature and the current humidity
6.1.9 Configuration of Altech V3 IP Base station
This menu allows to configure the Altech V3 IP Base station in standalone operation.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol “ “ and confirm the selection by shortly pressing the set-
ting wheel.
If the room control unit is taught-in to more than one base stations, select
the desired base station with the setting wheel.
The device parameters “UnP1/UnP2” and the channel parameters “ChAn” are avail-
able in the configuration menu for the Altech V3 IP Base station; these parameters