#852 • AR-7E Rotisserie Opera ti on & C ar e Ma nual • 8
I N S TA L L AT I O N
S TA C K I N G I N S T R U C T I O N S
A
rotisserie can be stacked with another rotisserie or can
be stacked on top of a matching holding cabinet.
NOTE: The AR-7VH Ventless Hood cannot be installed
when a rotisserie is positioned at the bottom of the
stacking combination.
Only screws, lock washers, and hex nut are required to
fasten units together when stacking a rotisserie on top of a
matching holding cabinet. Additional stacking hardware is
required for all other combinations (SEE PREVIOUS PAGE).
All fastening holes have been prepunched. If the rotisserie
oven is positioned at the bottom of a stacked configuration,
make certain the oven is on a non-combustible surface. The
stacking combination also requires the minimum clearance
of 6-inches (152mm) at the back and both sides.
Remove the two side access panels of both units.
Remove the vent cover plate from the top of the upper unit.
Punch out the knock out hole in the bottom of the upper
unit for accepting the exhaust tube from the lower unit.
(N
OT SHOWN ON ILLUSTRATION
)
Carefully lift and place the upper unit into position
aligning on bottom unit.
Secure units together by inserting a hex head screw, a
flat washer, and a lock washer in each hole of the top
unit and screwing them into the inserts provided on the
top of the lower unit. Securely tighten all four screws.
Inside the left side of the upper unit, install the exhaust
tube weldment routing it out the top of the upper unit
and then mating it with the exhaust vent of the lower
unit. Apply Red RTV to seal where the weldment
couples with the lower exhaust vent. (SEE BELOW)
Re-Install the vent cover plate on upper unit.
Replace the side panels on both units.
REMOVE COVER
PLATE AND SCREWS
ON LOWER UNIT
PRIOR TO MOUNTING.
(4) 1/4-20 INSERTS
PROVIDED IN TOP
COVER OF AR-7E
SIDE PANEL AND
SIDE COVER NOT
S
HOWN FOR CLARITY
Vent Cover Plate
(4) THRU HOLES PROVIDED
IN BOTTOM BASE OF AR-7E.
(4) 1/4-20 X 3/4" HEX HEAD SCREWS
(4) 1/4 DIA. FLAT WASHER
(4) 1/4 DIA. LOCK WASHER
EXHAUST TUBE WELDMENT
PART No.5007045
NOTE: SEE ASSEMBLY No.5006291
FOR COMPLETE PART LISTING.
2
2
11
66
7
7
55
55
4
5
6
3
2
APPLY RED RTV
ALL AROUND
APPLY RED RTV
ALL AROUND
1
AR-7E OVER AR-7E ROTISSERIE STACKING ASSEMBLY (5006291)
ITEM
NO
.
PART
NO
.
PART DESCRIPTION QTY
1 1007892 PIPE, EXHAUST, 1 1/2" SCH.5 1
2 5007045 WELDMENT, TUBE, EXHAUST 1
3 SC-2459 8-32 x 1/4" PHIL SCREW 6
4 SC-27385 SCREW, 1/4-20 X 3/4" LG HEX HEAD 4
5 WS-2294 WASHER 1/4" SPLIT 4
6 WS-22094 WASHER, 1/4", FLAT, 5/8 OD 18-8 SS 4
To Next Page
Loading...
