EasyManua.ls Logo

Alto-Shaam COMBITHERM CTP10-20G

Alto-Shaam COMBITHERM CTP10-20G
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CTP Combitherm
MN-35948
Rev 16
10/18
Combitherm® CT PROformance™ Series Operator’s Manual
69
12-Month Inspection Checklist
G
Inspect - The heat exchanger for any signs of major deformation. If yes, immediately remove from service and take corrective
action steps.
G
Inspect - The heat exchanger for any loose/disconnected pipes or flanges. If yes, immediately remove from service and take
corrective action steps.
G Inspect and Ensure - Exhaust pipes are exiting the oven cavity
G Inspect - Heat exchanger flange gasket (replace as needed)
G Inspect and Tighten - Heat exchanger flange bolts
G Inspect and Tighten - Heat exchanger burner flange hardware & gasket (replace as needed)
G Inspect and Tighten - Heat exchanger igniter flange hardware & gasket (replace as needed)
G Inspect - Heat exchanger exhaust pipes (ensure they are exiting out past the oven cavity ceiling flange) - ESG models only
G Inspect - Oven cavity ceiling flange & flange gasket - ESG models only
G Tighten - Burner flange bolts
G Tighten - Igniter flange bolts
Inspect - Heat exchanger weep holes to ensure they are free of obstructions (if the hole is obstructed, immediately remove oven
from service and replace the heat exchanger) - Not applicable to CTP/CTC models
E Inspect - Convection elements for signs of cracking, deformation, or damage
Replace - Oven lamp cover(s) & gasket(s)
Descale the oven interior
Inspect - Upper and lower door hinges and pins
Inspect - Door gasket (replace as needed)
Inspect - Door upper and lower hinges (replace as needed)
Wipe the inner door glass
Inspect - Front drip tray (clean as needed)
Inspect - Front drip tray hose
Inspect - Control overlay
Inspect and Tighten - All electrical connections
Inspect and Tighten - All cooling fans for proper operation
EB Electric boiler units only EG Gas units only Electric units only
Unit Information
Business Name: _______________________________________
Model Number: _______________________________________
Serial Number: ______________________________
12-Month Inspection Start Date: ______________________________

Table of Contents

Other manuals for Alto-Shaam COMBITHERM CTP10-20G

Related product manuals