TH/SK SerieS (rev. 2) • inSTallaTion/operaTion/Service manual - pg. 12
ENSURE POWER SOURCE
MATCHES VOLTAGE IDENTIFIED
ON APPLIANCE RATING TAG.
Item Description Qty
1 Double-Sided Tape 1
2 Drip Tray Holder 1
3 8-32 x 1/4” Phil Screw 3
4 Drip Tray 1
1. Poke holes through double-sided tape A which is attached to the back of drip tray holder B.
2. Remove backing on double-sided tape A.
3. Put screws C through holes and attach drip tray holder B to unit.
4. Optional - apply a line of food-grade silicone caulk along top edge of drip tray holder B to seal.
5. Place drip tray D in drip tray holder B.
A
B
C
D
To Next Page
Loading...
