#6001 COMBITHERM ELECTRIC INSTALLATION AND MAINTENANCE MANUAL
PG. 25
AUTOMATIC CLEANING PROGRAM
The Combitherm automatic cleaning function selects the
proper temperature for each step of the cleaning process.
With the oven power on:
PRESS THE CHEF FUNCTION KEY.
Rotate the adjustment knob until the clean symbol is highlighted in the display.
PRESS THE CHEF FUNCTION KEY.
Press the up and down arrow keys or rotate
the adjustment knob to select YES for the automatic
cleaning function.
PRESS THE CHEF FUNCTION KEY TO CONFIRM THE SETTING AND START THE
CLEANING PROGRAM.
THE OVEN WILL BEGIN A 20 MINUTE, 2-STEP CLEANING CYCLE.
• 10 minutes at 86°F (30°C) to allow the cleaning agent to work
• 10 minutes at full steam temperature of 212°F (100°C) to clean the oven
FOR DELUXE OVENS WITH A PROGRAMMED MENU KEY
FOLLOW STEPS 1 THROUGH 6 ON THE PRECEDING PAGE.
With the oven power on:
PRESS THE PROGRAMMED MENU KEY.
Rotate the adjustment knob to program 250 = CLEAN.
PRESS THE START KEY.
DELUXE MODELS CAN ALSO BE CLEANED AS SHOWN IN THE PREVIOUS INSTRUCTIONS.
7. When the buzzer signals the end of the cleaning process, press the start/stop key to
deactivate the audible signal or open the oven door.
8. With the door open, use the hand held hose and direct a stream of water into the Steam By-Pass Port
to rinse away oven cleaner residue.
9. Rinse the interior and all sprayed components with the hand-held hose. Make certain to thoroughly
rinse all surfaces to remove any cleaning solution residue. Use a non-abrasive cleaning pad for any
problem areas.
10. Loosen the thumb screw(s) and swing Fan Guard Cover Plate toward the back of the oven.
Thoroughly rinse the back of the Fan Guard Cover Plate, the oven fan, and the left-hand side of the
oven. Close the swing out Cover Plate . Lock the cover into place and tighten thumb screw(s).
LEAVE DOOR SLIGHTLY OPEN AFTER CLEANING
Clean
➡
➡
➡
COMBITHERM
®
CLEANING & MAINTENANCE
STANDARD CONTROL
DELUXE CONTROL
To Next Page
Loading...
Need help?
General
