To Next Page
J
Jenny CamachoSep 23, 2025
What does error E-B1 mean on my Alto-Shaam AR-7T?
- SShari HughesSep 23, 2025
Error E-B1 means the PCB temperature sensor is open-circuit. This is caused by board failure.
What does error E-B1 mean on my Alto-Shaam AR-7T?
Error E-B1 means the PCB temperature sensor is open-circuit. This is caused by board failure.
What does error E-70 mean on my Alto-Shaam AR-7T Oven?
Error E-70 means the personality wiring is incorrect, and does not equate to a supported configuration. This can be caused by incorrect personality wiring, a broken wire, board issues reading personality jumpers, or old software with a new configuration.
What does error E-10 mean on my Alto-Shaam AR-7T?
Error E-10 indicates that the N6 cavity sensor is short-circuit. This may be due to an error at the sensor input, the wrong RTD type (100? vs. 1000?), wiring issues, or a bad board at the sensor input. Check the wiring and ensure the correct RTD type is used.
What does error E-11 mean on my Alto-Shaam AR-7T?
Error E-11 indicates that the N6 cavity sensor is open-circuit. This can be due to an error at the sensor input, the wrong RTD type (100? vs. 1000?), wiring issues, or a faulty board at the sensor input. Check the wiring and ensure the correct RTD type is used.
What does error E-I0 mean on my Alto-Shaam AR-7T?
Error E-I0 means that the inline water heater sensor has a short circuit. This is caused by damaged sensor wires. Check the sensor wires for any damage.
What does error EADC mean on my Alto-Shaam AR-7T?
Error EADC may be due to a failing microprocessor or a cold solder joint on the CB.
What does error E-I2 mean on my Alto-Shaam Oven?
Error E-I2 means the water heater sensor is over temperature.
What does error E-B2 mean on my Alto-Shaam Oven?
Error E-B2 means the PCB is over-temperature of 70°C. This can be caused by a possible cooling fan failure in the control area, a possible runaway heater, being too close to another piece of equipment, or inadequate ventilation.
What does error E-83 mean on my Alto-Shaam AR-7T Oven?
Error E-83 indicates that the EEPROM is not responding. This is due to a failing EEPROM.
What does error E-44 mean on my Alto-Shaam Oven?
Error E-44 means that the touch driver is detected, but not responding to queries. This is due to a touch chip error on the board.
Explanation of danger, warning, caution, and notice labels.
Guidelines for safe operation and handling of the appliance.
Guidelines for maintenance and repair personnel.
Step-by-step guide for the liquid cleaning cycle.
Step-by-step guide for the tablet cleaning cycle.
List of error codes, descriptions, and potential causes.
Diagnostic steps for power-related issues.
Troubleshooting guide for heating element problems.
Steps to diagnose and fix spit motor failures.
Steps to diagnose and fix convection fan motor failures.
Steps to diagnose and fix wash pump failures.
Steps to diagnose and fix drain pump failures.
Steps to diagnose and fix grease pump failures.
Steps to diagnose and fix liquid cleaner pump failures.
Troubleshooting for water heater heating issues.
General| Brand | Alto-Shaam |
|---|---|
| Model | AR-7T |
| Category | Oven |
| Language | English |
