12
22
23
26
27
4.19 PHONES
23
4.22 CTRL ROOM OUTPUT Connectors
These 1/4" sockets are used to send the control room signal to
the studio monitor speakers or a second set of PA.
26
LEFT
MAIN MIX OUTPUT
RIGHT
AUX SENDS
RIGHT
STEREO AUX RETURNS
LEFT
RIGHT
CTRL ROOM OUTPUT
PHONES
LEFT(MONO)
2-TRACK IN/OUT
L
TAPE IN
TAPE OUT
R
4.18 2TK IN/OUT Connectors
-. TAPE IN
-. TAPE OUT
Use the tape input if you wish to listen to your mix from a taper
recorder or DAT. You can assign the signal coming from the taper
recorder either to a pair of studio monitor using the control room
assignment on the front panel or you can also send the signal
directly to the main mix.
These RCA jacks will route the main mix into a tape recorder.
22
4.17 PHONES/CTRL ROOM Control
This control sets the amount of signal sent to the control room and headphone.
21
4.20 AUX SENDS Connector
24
This 1/4" socket is used to send out the signal from the AUX bus
to external devices such effects.
4.21 STEREO AUX RETURNS Connectors
25
Use the stereo 1/4" sockets to return the sound of an effect unit
to the main mix. You can also use them as the extra auxiliary
inputs.
4.23 MAIN MIX OUTPUT Connectors
27
Through the main mix level control, you can adjust the output level
from - to +15dB.
The stereo output is supplied with 1/4" TRS sockets, which is used
to send the audio signal to an amplifier.
24
25
26
27
This 1/4" socket will send out the mix signal to a pair of head-
phones.
To Next Page
Loading...
