Alto AMX-100FX - 24 BIT DIGITAL EFFECTS (For AMX-100 FX Model); Effect Selection and Operation; External Effect Control

13
DFX MUTE
PRESETS
10
8
9
1
12
11
7
4
5
6
3
2
13
14
15
16
10
8
9
1
12
11
7
4
5
6
3
2
13
14
15
16
VARIATIONS
PEAK
14. REV. + DELAY
16. REV. + CHORUS
15. FLANGERREV. +
5. LARGE ROOM
13. CHORUS
12. FLANGER
11. STEREO DELAY
10. MONO DELAY
9. SPRING REVERB
8. TAPE REVERB
7. PLATE
6. SMALL ROOM
4. SMALL HALL
3. LARGE HALL
2. VOCAL 2
1. VOCAL 1
4.24 24 BIT DIGITAL EFFECTS (For AMX-100FX Model)
Adjust this knob to select the right effect you wish to perform.
There are total 16 options for you: several kinds of reverb, mono
and stereo delay, effects with modulation, and versatile two-effect
combination.
-. PRESETS Control
28
This switch is used to activate/deactivate the effect facility.
Sometimes, you can also use the DFX FOOTSWITCH for con-
venient operation.
-. DFX MUTE Switch
30
This LED lights up when the input signal is too strong.
In case of the digital effect module being muted, this LED also
lights up.
-. PEAK LED
31
-. VARIATIONS Control
29
Since you have selected the preferable effect, the next step, please
go with the fine consideration, there are also total 16 variations for
each preset. Each variation may be managed by several different
factors.
-. DFX FOOTSWITCH Connector
32
This 1/4" phone jack can be used to connect an external foot-
switch to turn on/off the onboard effect module.
DSP
FOOTSWITCH
28
29
30
31
32