2
Once you have finished your working session you shall turn the mixer off AFTER the
power amplifier. Before disconnecting the AC Adapter always turn-off your
.Do not use solvents to clean your . A dry and
clean cloth will be OK.
LYNX-MIX62(FX) LYNX-MIX62(FX)
This is the fastest way to get something out from your LYNX-MIX62(FX), if you
have a keyboard and a microphone.
d. Turn down AUX and LEVEL controls on the input channel.
3. QUICK START
e. Put the EQ controls on center position.
a. With the Main switch in OFF position, connect the supplied AC Adapter to your
first and then into the AC outlet, making sure that theLYNX-MIX62(FX)
available voltage is the same with your .LYNX-MIX62(FX)
b. Before turning on the , you shall connect it to a power amplifier
and speakers. Turning off the mixer BEFORE the power amplifier.
LYNX-MIX62(FX)
c. Plug the microphone into Channel 1 MIC IN.
f. Turn on your .LYNX-MIX62(FX)
g. With LEVEL control on "0" position, sing or speak in to the microphone with
normal volume and adjust the GAIN control so that the PEAK LED only blink
occasionally.
h. If you like, you can adjust the equalization at this stage.
i. Turn up MAIN MIX LEVEL until you get a comfortable volume.
j. Connect your stereo keyboard into CH 3/4 and repeat the same sequence.
Here you are. It is your first mix with your .LYNX-MIX62(FX)
To Next Page
Loading...
Need help?
General
