Alto MC700.4 User Manual

12345678910
12345678910
CH1 MODE SWITCHES CH2
INPUTS
CH1
CH2
CH3 MODE SWITCHES Ch4
Ch3
Ch4
CH3
CH4
BRIDGE
MONO
BRIDGE
MONO
CH2
CH1
INPUTS
AC INPUT
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
BREAKER
OUTPUTS
5.2 Operate MC700.4 Power Amplifier In Parallel Mode
In this mode, the channel 1 input signal will be output from the output connectors of both channel 1 and channel
2. The channel 2 input jack is not used. The channel 1 and channel 2 volumes can be adjusted independently.
+
Channel 1
12345678910
12345678910
CH1 MODE SWITCHES CH2
INPUTS
CH1
CH2
CH3 MODE SWITCHES Ch4
Ch3
Ch4
CH3
CH4
BRIDGE
MONO
BRIDGE
MONO
CH2
CH1
INPUTS
AC INPUT
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
BREAKER
OUTPUTS
Channel 2
Channel 1
+
++
PARALLEL MODE
12345678910
Channel 1
9
5.3 Operate MC700.4 In Bridge Mode
In this mode, the channel 1 input signal will be output from the bridge output connectors. In this case, use the channel 1
volume control to adjust the volume. keep the volume control of channel 2 turned completely down (counterclockwise).
Then, you can control the volume of the whole system by adjusting the channel 1 volume control.
BRIDGE MODE
12
3
4
56
7
8910

Alto MC700.4 Specifications

General

Brand	Alto
Model	MC700.4
Category	Amplifier
Language	English