Need help?Do you have a question about the Alto RMX1008 DFX and is the answer not in the manual?
Mono Input Channels| frequency response (microphone input) | 10Hz to 55kHz, +/–3dB |
|---|---|
| distortion (microphone input) | 0.006% at +4dBu, 1kHz |
| gain (microphone input) | 50dB |
| SNR (Signal to Noise Ratio) | >90dB |
| frequency response (line input) | 10Hz to 55kHz, +/–3dB |
| distortion (line input) | 0.04% at +4dBu, 1kHz |
| gain (line input) | 30dB |
Stereo Input Channels| frequency response | 10Hz to 55kHz, +/–3dB |
|---|---|
| distortion | 0.006% at +4dBu, 1kHz |
Impedances| microphone input impedance | 1.4k Ohm |
|---|---|
| channel insert return impedance | 2.5k Ohm |
| all other inputs impedance | 10k Ohm or greater |
| tape out impedance | 1k Ohm |
| all other outputs impedance | 120 Ohm |
Equalization| hi shelving | +/-15dB @12kHz |
|---|---|
| mid bell | +/-15dB @2.5kHz |
| low shelving | +/-15dB @ 80Hz |
DSP Section| A/D and D/A converters | 24-bit |
|---|---|
| DSP resolution | 24-bit |
Effects| presets | 16 |
|---|---|
| controls | 16-position PRESET Selector; 16-position Variation selector; Clip LED; Mute Switch with LED indicator |
Output Power| stereo mode power (RMS) | 400W @ 4ohm, 254W @ 8ohm |
|---|---|
| stereo mode power (EIAJ) | 480W @ 4ohm |
| bridge mode power | 945W @ 8ohm, 263W(EIAJ) @ 8ohm |
Power Supply| main voltage | 100-120 VAC~60 Hz 210-240 VAC~50 Hz |
|---|---|
| fuse | 100 ~ 120V, T8 A 250V; 220 ~ 240V- T6.3 A 250V |
| inrush current at initial switch-on | 3.82 A |
| inrush current after power supply interruption | 5.43 A |
Weight and Dimensions| dimensions (W x L x H) | 550mm x 220mm x 310mm (8.66" x 12.20" x 21.65") |
|---|---|
| net weight | 8.0kg (17.63lb) |
To Next Page
