To Next PageTo Next Page
Need help?Do you have a question about the Alto TW 300 CAR and is the answer not in the manual?
General| Brand | Alto |
|---|---|
| Model | TW 300 CAR |
| Category | Floor Machine |
| Language | English |
Guidelines for safe handling and inspection of the machine's mains lead.
Ensure machine voltage matches the rating plate specification.
Connect only to a fused socket with at least a 10A fuse.
Instructions for mixing hot water with liquid or powder cleansing agents.
Warning against using foaming shampoos; only approved low-foam agents are permitted.
Using ALTO Foam STOP additive to prevent excessive foaming in the dirty water tank.
Turn on both the suction unit and the cleansing agent pump switches.
Position spray nozzle and operate metering valve for cleaning strokes.
Pull nozzle backward gradually, overlap strokes by approximately 2 cm.
Apply cleansing agent with metering valve open, suction motor off, let it act.
Repeat cleaning process, preferably at right angles, only on dried carpet.
Refer electrical faults and complex repairs to authorized service personnel.
Possible cause: Power supply interrupted. Remedy: Check lead, plug, fuse.
Causes include clogged nozzle or filter, or empty fresh water tank.
Potential issues: loose lid, clogged nozzle, air leaks, full tank, or blocked filter.
