2.2.11. SD Card
The APS-3 comes pre-installed with a 2GB SD Card for internal data logging.
When using with APS-3 for data logging, it will record data in SBF (Septentrio Binary
Format), which can be converted into RINEX format for Post Processing.
Handle the SD Card with care. When not in use, leave it inside the APS-3 or place it
in SD Card Holder for transportation or storage.
A 2GB SD Card has capacity of ~8.8 days at 1Hz data rate. Memory is used at
9.4 MB/hr when logging default data at 1Hz.
File Information:
Format: Septentrio Binary Format (SBF)
Size: Up to 72kB per second
Turn OFF the APS-3 to install or remove SD card. Data loss and corruption may occur
if SD Card is removed while APS-3 is ON.
2.2.11.1. Removing SD Card
Unlock SIM & SD Card compartment on the back of the
APS-3
Open SIM & SD Card compartment
Push SD Card to release locking mechanism
Pull SD Card out of the slot
2.2.11.2. Installing SD Card
Unlock SIM & SD Card compartment on the back of the
APS-3
Open SIM & SD Card compartment
Insert SD Card using the guide
Push SD Card into the slot until it locks into place
To Next Page
Loading...