3.3.3. APS-3 Battery Installation and Replacement
Removing the battery in use will cause the APS-3 to restart or turn OFF. Use the
battery status indicator in data collection software to confirm which battery is “in
use” before hot-swapping batteries.
Press button to open battery door compartment
Use the guide to slide the battery into the APS-3
Swivel the battery door compartment up and push from the bottom until it latches
completely
How long can each
battery last when using
APS-3?
A battery can last 4 - 5 hours
Will the APS-3 swap to a
fully charged battery if
one discharges?
Yes. No user action is required
Can I remove one of the
batteries while the APS-3
is in use?
Before battery removal, use data collection software
to check which battery is in use. Remove the battery
not in use
How long does it take to
charge a battery?
It takes 2 hours to fully charge a battery
How do I know if battery
is fully charged?
Battery bay LED turns Green when fully charged
Contact a Recycling Center to ensure proper disposal of lithium-ion
Batteries.
To Next Page
Loading...