6.25. Question: How do I stop the APS-3 from logging automatically on startup?
Answer: Earlier versions than 2.55 of SurvCE saved settings to the receiver
boot. These earlier versions recalled the settings set during the last
configuration and uses these upon restart. To stop logging upon startup,
Close the Data File and reconfigure the base/rover. Reconfigure by selecting
the green check mark on GPS Base/Rover tab.Else upgrade SurvCE to version
2.55.
6.26. Question: Why does SurvCE give me an error message when trying to
configure the internal Arwest UHF radio to Satel protocol?
Answer: Verify that you have the appropriate firmware (1.8 Rev 1B3 or later)
loaded onto the internal radio, which allows for this selection. This firmware
can be found in the download section of the ALTUS support webpage.
6.27. Question: How do I start/stop raw data logging?
Answer: Select the wrench in the upper right-hand corner of the map screen
to open the Instrument Settings menu. Select Raw Data Logging and select
start/stop logging.
6.28. Question: How do I switch between reference and rover?
Answer: Select the wrench in the upper right-hand corner of the map screen
to open the Instrument Settings menu. Select Instrument Disconnect. Back in
the Map View, select the wrench again to open the Instrument Selection
menu. From here you can select your GPS Reference or GPS Rover profiles.
6.29. Question: Why don't I see the Satel protocol option while configuring my
internal Arwest radio?
Answer: Verify that you have the appropriate firmware (1.8 Rev 1B3 or later)
loaded onto the internal radio, which allows for this selection. This firmware
can be found in the Support section of the ALTUS website.
To Next Page
Loading...