English
(10)
Control Panel
Power Control
The power control turns the unit on and off.
Light
Unit will not operate if this light is lit. Drain water
by removing plug from the bottom back of the
unit. (See page 7 for details.)
Mode Control
The mode control has 3 settings:
• Cool • Dehumidifier
• Heating/Fan (Model AP125HD Only)
The settings are adjusted with Mode Control
button. A green light will indicate which setting
is currently being used.
Cooling Mode
• During the cooling mode the air is cooled
and hot air is vented to the outside through
the exhaust tube.
• Adjust fan speed and temperature to suit
your desired comfort level.
Dehumidifier Mode
• Air is dehumidified as it passes through the
air conditioner, without being in full cooling
mode. (Note: The warm air exhaust hose
must vent inside the room, not outside as it
does when cooling. If the unit is vented
outside some cooling will occur.)
Heating Mode - Model AP125HD Only
(LED in Red)
• In heating mode, the air flow is selectable.
(Note: Heating is activated only when the
ambient temperature is below 77˚ F.)
Fan Mode (LED in Yellow)
• Air is circulated throughout the room with
no cooling. (Note: Unit does not need to be
vented in Fan mode.)
Fan Speed
The Fan Speed Control has three settings: High,
Medium or Low. In the Dehumidifier or Dry
Mode, the fan will only operate at low speed.
To Next Page
Loading...
Need help?
General
