To Next PageTo Next PageWhat to do if my Amana Air Conditioner unit does not start?
If your Amana Air Conditioner doesn't start, check these potential causes: * Ensure the unit is securely plugged into the wall receptacle and that the plug's test/reset button hasn't tripped. * Replace the fuse if it has blown. * Reset the circuit breaker if it has tripped. * Make sure the unit is turned on using the bottom right button on the keypad.
Why is my Amana Air Conditioner not cooling or heating the room properly?
If your Amana Air Conditioner isn't cooling or heating the room effectively, consider the following: * Ensure curtains, blinds, or furniture aren't blocking the unit's airflow. * Adjust the temperature setting to a lower or higher temperature. * Clean or replace dirty air filters. * Allow the unit sufficient time to heat or cool the room, especially when starting in excessively hot or cold conditions. Starting early can help maintain comfort. * Close any open vent doors. * Check the dip switch and wall thermostat settings. * If the compressor is in time delay, wait approximately 3 minutes for it to start.
What to do if ice forms on the indoor coil of my Amana distinctions DHP123A35AA Air Conditioner?
If ice or frost forms on the indoor coil of your Amana Air Conditioner: * If the outdoor temperature is approximately 55°F or below, switch the unit to FAN operation until the ice or frost melts. * Remove and clean the filters, as dirty filters can contribute to ice formation.
What does compressor protection mean on my Amana distinctions DHP123A35AA?
Compressor protection on your Amana Air Conditioner refers to features designed to prevent damage. If the power has cycled, the compressor may be in a restart protection mode. After a power outage, the compressor will restart after approximately 3 minutes. To prevent short cycling, there is a random startup delay and a minimum compressor run time of 3 minutes.
What to do if my Amana distinctions DHP123A35AA display has strange numbers or characters?
If your Amana Air Conditioner display shows strange numbers or characters: * The unit may be in a protection mode. * The unit may be set to display temperatures in °C instead of °F.
What to do if water is dripping inside my Amana Air Conditioner?
If water is dripping inside your Amana Air Conditioner, the wall sleeve must be installed level to ensure proper condensation drainage. Check the installation and make necessary adjustments to ensure it is level.
General| Brand | Amana |
|---|---|
| Model | distinctions DHP123A35AA |
| Category | Air Conditioner |
| Language | English |
Installer's obligation to know safety precautions and product details.
Only trained personnel should install, adjust, service, or repair the equipment.
Installation and servicing must be performed by qualified, experienced technicians.
Instructions to prevent injury and property damage with classified indications.
Covers electrical safety, wet rooms, cord placement, speed controls, and thunderstorms.
Earthing, unit modification, water in electric parts, circuit breakers, sockets.
Warnings about flammable materials, heating appliances, gas leaks, and ventilation.
Details the power cord's current detection device and replacement policy.
Ensuring adequate service, proper grounding, and receptacle requirements.
Detailed table of dip switch configurations and their functions.
Table detailing dip switch configurations accessible via the panel.
Warnings about sharp edges, weight, and the need for assistance.
Common causes and solutions for the unit not starting.
Troubleshooting cooling/heating problems, display errors, and noises.
