To Next PageTo Next Page
Need help?Do you have a question about the Amana M9C96 Series and is the answer not in the manual?
Warnings regarding gas leaks, open flames, and flammable materials.
Cautions about freezing hazards and improper installation.
Covers improper installation, flammable liquids, and gas smell procedures.
Overview of the furnace's capabilities and components.
Defines intended uses and limitations for the furnace.
Specifies criteria for choosing an appropriate installation site.
Details required space around the unit for service and operation.
Guidelines for optimal thermostat placement.
Importance of fresh air for safe and proper furnace operation.
Illustrates various furnace orientations and duct connections.
Specific advice for horizontal furnace installations.
Requirements for converting to propane or installing at high altitudes.
Lists approved materials and standards for vent and intake piping.
Installation and maintenance of the condensate drainage system.
Details on wiring the furnace's power supply and accessories.
Steps to move the electrical junction box for side connections.
Diagrams and instructions for connecting thermostats.
Procedures for measuring and adjusting gas pressures.
Steps and kits required for converting to propane gas.
Guidelines for safe and code-compliant gas line installation.
Step-by-step guide for safely starting the furnace.
Correct procedure for turning off the furnace.
Measuring input rate and adjusting temperature rise.
Describes the furnace's operational cycles and blower speed control.
Annual checks for proper furnace operation and safety components.
Instructions for filter replacement, removal, and maintenance.
Visual inspection of burner flames for proper operation and appearance.
Details integrated control module, limits, switches, and flame sensor.
Covers static discharge prevention, lockouts, and reset methods.
Guide to diagnose and correct operational problems using LED status.
Visual representation of all electrical connections and components.
Checklist for recording electrical, pressure, and temperature measurements.
Mandates for CO detectors and signage in MA.
General
