2
I. Safety Information
Important
To The Installer
Before installing this unit please read this manual and
the Specification Sheet to familiarize yourself on the
specific items which must be adhered to such as maxi-
mum external static pressure to unit, air temperature
rise, minimum or maximum CFM and motor speed
connections.
To The Owner
It is important to complete the owner registration card
and mail it immediately. This will assist Amana in con-
tacting you if any service or warranty information should
change in the future. When completing the registration
card, be sure to include the Model, Manufacturing and
Serial Numbers, plus the installation date.
The warranty certificate is also supplied with the unit.
Read the warranty carefully and note what is covered.
Keep the warranty certificate in a safe place so you can
find it if necessary.
If additional operating instructions are required, call the
dealer where the purchase was made. Keep this litera-
ture in a safe place for future reference.
WARNING
To prevent death, personal injury or prop-
erty damage, do not use this unit if any
part of the unit has been under water.
Immediately call a qualified service tech-
nician to inspect the unit and to replace
any part of the control system which has
been under water.
WARNING
To prevent death, personal injury, or
property damage due to improper instal-
lation, adjustments, alterations, service
or maintenance, when servicing or per-
forming maintenance to this unit consult
this manual, the service manual, a quali-
fied installer, a service agency.
WARNING
This product contains or produces a
chemical(s) which may cause death or
serious illness and which are known by
the State of California to cause cancer,
birth defects or other reproductive harm.
Locating The Unit
WARNING
To prevent death, personal injury, prop-
erty damage or equipment damage, the
following points must be observed when
installing the unit.
All Installations:
Ground Level Installations Only:
• When the unit is installed on the ground adjacent to
the building, a level concrete (or equal) base is
recommended. Prepare a base the same physical
size as the unit or slightly larger and 3 inches thick.
• The base should also be located where no runoff of
water from higher ground can collect in the unit.
Rooftop Installations Only:
• To avoid possible personal injury or property dam-
age, the roof must have sufficient structural strength
to carry the weight of the unit(s) and snow or water
loads as required by local codes.
• If horizontal air delivery is used, the unit may be
installed directly on wood floors or on Class A,
Class B, or Class C roof covering material.
• To avoid possible personal injury, a safe, flat sur-
face for service personnel must be provided.
• If vertical air discharge is used and the unit is
installed on combustible flooring or class A, B, or C
roofing material, then the Amana roof curb (PRC01*)
is required.
II. General Information
This unit is approved only for an outdoor installa-
tion.
To assure that your unit operates safely and effi-
ciently, it must be installed, operated, and maintained in
accordance with these installation and operating in-
structions, all local building codes and ordinances.
The heating and cooling capacities of the unit should be
greater than or equal to the design heating and cooling
loads of the area to be conditioned. The loads should be
calculated by an approved method or in accordance
with A.S.H.R.A.E. Guide or Manual J - Load Calcula-
tions published by the Air Conditioning Contractors of
America.
Obtain from:
American National Standards Institute
1430 Broadway
New York, NY 10018
To Next Page
Loading...
Need help?
General
