10
Multiple Heating Stages
Oven can be programmed to perform 4 independent
heating cycles without interruption.
1. Open oven door.
• Display shows .
• Fan and light operate.
• If door is closed or
(RESET)
pad is pressed
before finishing programming sequence, oven
exits programming mode.
2. Press pad
1
for approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
“P”.
3. Press desired number pad.
• Display shows heating time and power level
indicator (if other than 100 percent power),
and pad number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
5. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
6. Press
(TIME ENTRY)
pad.
• Display briefly shows “P2” indicating menu,
programming stage. Then cook time and power
level for stage show in display.
• Repeat steps 5-8 to create up to 4
additional stages.
7. Press
(START)
pad to save new heating time
and power level in oven memory.
8. Press
(RESET)
pad or close oven door to exit
programming mode.
Programming
Preprogrammed Number Pads
1. Open oven door.
• Display shows .
• Fan and light operate.
• If door is closed or
(RESET)
pad is pressed
before finishing programming sequence, oven
exits programming mode.
2. Press and hold pad
1
for approximately 15
seconds.
• After 15 seconds, signal sounds. Display
shows “P”.
3. Press desired number pad.
• Display shows heating time and power level
indicator (if other than 100 percent power), and
pad number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
5. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
6. Press
(START)
pad to save new heating time
and power level in oven memory.
• Display shows “P”.
• Repeat step 3-8 to program additional pads.
7. Press
(RESET)
pad or close oven door to exit
programming mode.
To Next Page
Loading...
Need help?
General
