Amana RFS511MP Series User Manual

9
Manual Time Entry
1. Open oven door, place food in oven, and close oven
door.
• Display shows .
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press (TIME ENTRY) pad.
• Display shows “0000” and .
3. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
4. Press a power level pad (if power level other than
100 percent is required).
• Display shows current power level indicator
(if other than 100 percent power).
5. Press (START) pad.
• Oven operates and time counts down.
• Display shows only when microwave energy
is present.
• If power level other than 100 percent power was
programmed, display shows power level indicator.
6. Oven stops heating and oven signal sounds when
heating timing elapses.
Reviewing Preprogrammed Pads
1. Open oven door.
• Display shows .
• Fan and light operate.
• If door is closed or (RESET) pad is pressed
before finishing programming sequence, oven
exits programming mode.
2. Press and hold (TIME ENTRY) pad for
approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
“P”.
3. Press desired number pad.
• Display shows heating time.
4. Press (TIME ENTRY) pad to review heating
stages for pad.
• “P” and stage show briefly, then heating time.
5. Press (START) pad after reviewing
preprogrammed pad.
• Repeat steps 3-6 to review another
preprogrammed pad.
6. Press (RESET) pad or close oven door to exit
programming mode.

Amana RFS511MP Series Specifications

General

Brand	Amana
Model	RFS511MP Series
Category	Microwave Oven
Language	English