Installation & Operation Guide Page 26 of 48
How to Restore Users From Time Guardian Software
You can retrieve the Users you just deleted at the terminal [location] from Time Guardian. Also, it is recommended to
utilize Time Guardian backup feature to protect the database which contains the maps, etc.
The sequence to restore users from Time Guardian is:
1. First press the button from the Time & Attendance Communications screen (see Using the Fingerprint
Commands ) to load employee ID's, etc. into the MTX-30 terminal.
2. Next press from the Time & Attendance Fingerprint Communications screen to transfer all template maps to the
terminal.
Communication Option Menu (MTX-30)
1. Press the M/┘ key and scroll (►) to Comm.
Note: Please verify network cable is connected first and power cycle the unit.
Network – Change DHCP from ON to OFF and write the IP Address to be used in the software configuration:
RS485 – Enable RS485 when using the AMANO USB Commstick. (Default is off).
Note: There is no conflict if RS485 is setup to ON but not used (connected).
To Next Page
Loading...
