Installation & Operation Guide Page 34 of 48
Use Step 8 if:
Do you have Terminals other than Access Control Terminals?
If Yes, Time Guardian will enable access and communications module.
If No, communications will be disabled until ready for clock setup.
Do you want to configure Terminal Validation?
If Yes is selected for Terminal Validation, click the Terminal Validation button and the Terminal Validation screen will appear .
Terminal validation provides employee filtering from the setup configured in the General, Department, and Employee tabs in Time
Guardian.
Terminal Validation is used to assign employees and Labor Levels to specific MTX-30 terminals in the system. When validation is
used, only employees assigned to a particular terminal with the selected Labor Levels can use that terminal. Labor transfers at the
terminal can only occur within the selected Labor Levels. Terminal Validations are downloaded to the selected MTX-30 terminals by
location from the Communications module. To do so, see Time Guardian User Guide for more detailed information:
Software Setup for Terminal Validation
Do you want to configure Bell Schedules?
If Yes is selected for Bell Schedules, click the Bell Schedule button for the Bell Schedules screen.
Software Setup for Bell Schedules
Note: Duration entered in the first line will be the same to as following lines.
To Next Page
Loading...
