Amantii E 50 - Operation; Manual Operation; Auto Mode

OPERATION
The fireplace can be operated
by the switches located on the left front of the fireplace unit or by
remote control (included).
MANUAL OPERATION
1.
The main power ON/OFF switch in position
2.
When main power ON/OFF switch is
3. Press the
button repeatedly to set the heater to desired heat setting.
LED will glow which shows the current heater
a) RED 1500W HEAT
OUTPUT
b) BLUE 750W HEAT
OUTPUT
c) PURPLE AUTO MODE
AUTO MODE
Under this mode the heater will automatically turn ON at high heat setting 1500W heat output when
the room te
mperature drops below 22
25℃(72-77℉
) the heater output will switch to low heat setting
goes above 25℃(77℉
) the heater will be turned
will be PURPLE in colour under this
4. Flame effect:
Press the button
will cycle through –Low-
Medium
5.
Mood light effect: Press the button
NOTE: If operated at
the Low heat setting, the fireplace will not provide as much heat as in the High
setting, however,
the low setting will not r
circuit, do not plug the firepla
ce into a circuit that already has other appliances working
When the fireplace is not in use,
switch
SAFETY CUT-OFF
 This appliance is fitted
with a safety
to blocked air vents). For safety reasons, the fireplace will
 To
reset the appliance, disconnect the appliance from the main supply for
Reconnect the suppl
y to the main and switch on the
8
by the switches located on the left front of the fireplace unit or by
The main power ON/OFF switch in position
O, the fireplace is OFF.
When main power ON/OFF switch is
at position I, the fireplace is ready to
button repeatedly to set the heater to desired heat
setting.
LED will glow which shows the current heater
settings.
OUTPUT
OUTPUT
Under this mode the heater will automatically turn ON at high heat setting 1500W heat output when
mperature drops below 22
℃(72℉
). When the room temperature is between 22
) the heater output will switch to low heat setting
750W.
When the room temperature
) the heater will be turned
off
and the cycle will continue. The LED ind
will be PURPLE in colour under this
mode.
Press the button
marked
to adjust the flame brightness. The flame brightness
Medium
-High -OFF.
Mood light effect: Press the button
marked to change the mood light
colour.
the Low heat setting, the fireplace will not provide as much heat as in the High
the low setting will not r
equire as much electrical power.
To
ce into a circuit that already has other appliances working
switch
off and unplug.
with a safety
cut-off
which will operate if the fireplace overheats (eg. Due
to blocked air vents). For safety reasons, the fire
place will NOT
automatically
reset the appliance, disconnect the appliance from
the main supply for
y to the main and switch on the
appliance.
by the switches located on the left front of the fi
replace unit or by
use.
button repeatedly to set the heater to desired heat setting.
The heater indicator
Under this mode the heater will automatically turn ON at high heat setting 1500W heat output when
). When the room temperature is between 22
-
When the room temperature
and the cycle will continue. The LED ind
icator
to adjust the flame brightness. The flame brightnes
s
colour.
the Low heat setting, the fireplace will not provide as much heat as in the High
To
avoid overloading the
ce into a circuit that already has other appliances
working connected.
which will operate if the fireplace overheats (eg.
Due
automatically
reset.
reset the appliance, disconnect the appliance from the main supply for
at least 10 minutes.