EN
4
7. Operation
7.1  Switching  on/o
 » Set the on/o switch (C) to I to switch the product on.
 » Press the   button to activate/deactivate the AUTO and 
manual shredding mode. The   button lights up blue or 
goes o accordingly.
 » Set the on/o switch (C) to O to switch the product o.
NOTICE
 After 30 minutes of idle time, the product enters 
sleeping mode. 
7.2 Control panel
AUTO
When in AUTO mode, the   button lights up blue.
The motor runs only when paper/card or CD/DVD is 
inserted into the feed slot, and stops automatically 
when the paper/card or CD/DVD has passed through.
To exit AUTO mode, press the    button again. The 
blue light goes o.
REV
Press to urgently stop the shredding process and keep 
pressing to roll out the unshredded portion of paper/
card or CD/DVD.
Use the   button to clear jammed material. 
FWD
Press the   button to manually start the shredding 
process.
7.3 Shredding
The product runs briey after each pass to clear entry. 
Continuous operation beyond 20 minutes triggers a 20‑minute 
cool down period.
7.3.1. Paper
NOTICE
 
 » Always set the on/o switch (C) to O and unplug the 
product when not in use.
 » Do not exceed the sheet count per pass (max. 12 sheets of 
75 g/m
2
 paper). Insert paper as straight as possible into 
paper/card feed slot (J) and release.
 » One folded sheet of paper equates to 2 sheets of paper. 
Heavier paper, humidity or a supply voltage lower than the 
rated voltage may reduce shredding capacity.
 » This product can shred staples and small paper clips. 
Remove paper clips whenever possible to extend the 
lifespan of the product.
7.3.2. Credit card
NOTICE
 
 » Only shred credit cards by feeding them vertically into 
the middle of the paper/card feed slot (J), releasing when 
shredding begins.
 » The sensor is located in the middle of the paper/card feed 
slot (J). Do not insert credit cards at the sides of the paper/
card feed slot (J). 
 » Never feed in more than one credit card at a time.
7.3.3. CD/DVD
 CAUTION
 Risk of injury!
 » Do not hold CD/DVD with nger through the center ring 
while feeding into the CD/DVD feed slot (K).
NOTICE
 
 » Never feed in more than one CD/DVD at a time.
 » Hold a CD/DVD by its edge, feed in one at a time and release 
when shredding begins.