Meanwhile, if you use the mode command, given that this command increments or decreases just
one step each time, then it often has to be repeated several times, so it is no longer necessary to
have the "last memory of the command", and it's easy to change the volume by saying volume
down or volume up. (Instead, you can repeat the last command with the repeat command)
Also you can send the following command to increase decrease the volume.
TV volume raise 5 steps
Volume of TV set lower 3 times
Mute Command
This command is used in audio and video media. And it can be cut off with that sound.
The keyword is the
Mute
command and its form is as follows:
{place.pos.device} Mute
Mute {place.pos.device}
Example:
Set the saloon's TV-Box mute
Mute the audio player
Mute the TV = Mute TV = Set TV to Mute = TV Mute
Security System Command
This command is purely for security system and can be configured with security mode.
The keyword is either
Security
or Safety and is used with {
mode
}, its form is as follows:
{place.pos.device} Security/Safety {mode}
Security/Safety of {place.pos.device} to {mode}
Example:
Set the security to away
Security of first floor change to night
Security of saloon to disarm = saloon security disarm = saloon security off
The mode options in this command are: away, night, night with gust, disarm, off, vacation, which
both disarm and off options, and this means disabling security, and other options depending on
the function of the module. Security in the zone is triggered by the security status.
Also, in this command, since the name of the keyword and tool name are equal, so there is no
need for the name of the device, but if specified for a specific area, the area name in the command
should be used.
To Next Page
Loading...
