6 7
Welcome to Device
Device gives you voice control and access to your cloud
music plus voice enabled music shopping, weather
forecasts and task management. This includes alarms,
timers, to-dos, and shopping lists. Using Bluetooth, you
can also stream music from your phone or tablet, or use
Device as a speakerphone.
Getting started is easy:
1.
Get the Device App.
2.
Register the device.
3.
Connect your phone, tablet, or laptop to your
Device.
4.
Connect your Device to your Wi-Fi.
Device overview Step 1: Get the Device app
a. Before you start, make sure that you know the name
(SSID) and password of your Wi-Fi network.
b. For an iOS or Android phone or tablet, install the Device
app from https://XXXXXX.com/start. For a laptop or
different phone or tablet, use your browser to go to ttps://
XXXXXX.com/start
Step 2: Register the Device
a. In the menu of the Device app, go to “Settings”, then
to “Add New Device”.
b. Enter the Device serial number.
c. Enter your ZIP code to indicate your location.
d. The app will show instructions on how to set up
your Device.
Step 3: Connect to your Device
a. Plug in the Device. The light ring will show a blue
animation.
b. The Device will automatically go to setup mode. The
blue animation will turn orange. If no orange
animation appears, press and hold the Active button
on top of the device until the orange animation
appears.
c. When the Device app tells you to connect to the
Device, go to the Wi-Fi settings page on your phone,
tablet or laptop.
d. Select the Wi-Fi network starting with “DIRECT-dp-”. If
you don’t see it, refresh the list. Enter the password
“1234567”. Your phone, tablet or laptop is now connected
to the Device.
Step 4: Connect your Device to Wi-Fi
a. Go back to the Device app. It will advance to the
next step after connecting to the Device.
b. You will see a list of Wi-Fi networks the Device can
connect to. Select your Wi-Fi and enter the password
for this network.
c. Click “Connect”. The Device will connect to your
Wi-Fi network. This might take a minute.
d. Click “Exit Wi-Fi Setup”. Your phone, tablet or laptop will
disconnect from the Device. The orange animation will
stop.
e. The Device will establish a connection to the Device
service via the Internet. This may take a while. When
this is done, you will hear a message. Your Device is
now set up.
Start using Device
Get Device’s attention by saying “XXX” (for devices
with a serial number ending with A to F) or
“YYY” (for serial numbers ending with G to Z). The
light ring will turn blue when XXX hears you.
Now you can say things like: “XXX, play some music”,
or “XXX, what’s the weather in New York?”
To adjust the volume, say things like “XXX, turn it up”,
or “XXX, volume down”, or rotate the top ring.
You can turn the microphones off by pressing the
microphone button.
Microphones
Active button
Volume ring
Mics on/off button
Light ring
Status light
2
3 4 5
To Next Page
Need help?
General
