To Next PageTo Next Page
Need help?Do you have a question about the Amazone ZA-F and is the answer not in the manual?
General| Brand | Amazone |
|---|---|
| Model | ZA-F |
| Category | Farm Equipment |
| Language | English |
The official instruction manual for the AMAZONE ZA-F precision broadcaster.
Defines improper use and manufacturer's non-responsibility for damages.
Basic safety principles, health, traffic rules, and operator conduct.
Addresses implement mounting, axle loads, towing, driving, danger zones, and maximum filling loads.
Covers parking, coupling, guards, tractor compatibility, and PTO safety.
Details safe practices for connecting, operating, and disconnecting the PTO shaft.
Addresses risks of high-pressure liquids and proper disposal of oils and filters.
Covers bolt tightening, supporting lifted implements, welding precautions, and hydraulic system safety.
Procedures for stored fertilizer and spreading specific types like superphosphate.
Daily greasing of shutter slide and weekly check of stirrer finger distance.
Washing out hopper, cleaning/greasing ball joints, and general lubrication.
Safety shear bolts, gearbox damage, and storing the PTO shaft.
Checking gearbox oil level and notes on wear from specific materials.
Instructions for assembling and connecting the PTO shaft to the tractor and spreader.
Guidance on adjusting handles and discs for desired spread pattern and bout width.
Covers calibration of spread rate, working width, and notes on fertilizer properties.
How to perform half bout width spreading and use of stirrer head stop.
Adjusting swivel blades for normal fertilizing and late top dressing.
Guidance on spreading pellets, safety precautions, and environmental care.
Installation and function of agitators and stirrer head drive stop.
Use of protective sieve and calibration box for rate checking.
Definition of effective spread width and fitting the calibration box.
Step-by-step guide to calibrate spread rate using collected material and multipliers.
Use of boundary limiter and foldable rolling device for easier handling.
Details on the band spreading device for accurate row placement.
Instructions for installing brackets for rear light carriers.
Fitting instructions for hydraulic shutter control types I & II.
Fitting instructions for hydraulic combi shutter control types I & II.
Step-by-step guide for removing, replacing, and fitting stirrer heads correctly.
Instructions for removing the gearbox, spinner discs, and mounting a replacement.
Procedures for checking and correcting shutter opening for symmetrical fertilizer distribution.
Guidance on mounting spinner vanes, noting short vane placement.
How to unbolt and replace stirrer base sealing rings.
