6.14 Electric shutter control with Amatron II.
6.15 Electric kcontrol with switchbox SKU.
7 Hints for adjustments
7.1 Checklng the baslc settlng of the shutter slldes
To ensure a symmetrical spread Pattern of both Spinner discs shutter openings wer8
set by the factory. In case of any malfunction they tan be checked as follows:
Secure the two shutter setting levers (Fig. 4/1) on the rear of the machine in Position
8 by tightening the wing nuts (Fig. 4/2). Then open the two shutter slides by using the
tractor’s hydraulics. Now the hopper outlets should be opened to such an extent
allowing a 12 mm drill to be easily pushed through.
If the opening is too narrow readjust the shutter setting lever to a higher setting no.
until the drill tan be easily pushed througt. Thereafter it is necessary to readjust the
pointer of the shutter lever (Fig. 4/3) to Position 8.
If tho opening is too wide proceed vice versa.
7.2
Amount of pressure in the tractor’s hydraullcs
The pressure of the hydraulic System of the tractor should never exceed 180 bar in
order to avoid bending dammage to the shutter setting levers.
32
To Next Page
